microswiss direct drive setup
Micro Swiss is a company that produces a direct drive extruder for various 3D printers. The direct drive extruder replaces the stock extruder on a 3D printer and provides improved performance, especially for printing with flexible materials like TPU.
Here are the general steps to set up a Micro Swiss direct drive extruder:
Remove the old extruder: Start by removing the old extruder from your 3D printer. This will involve removing any screws or bolts that are holding it in place, as well as any wiring that connects it to the printer.
Install the Micro Swiss extruder: Install the Micro Swiss direct drive extruder in place of the old one. Make sure that it is secured tightly in place and that any wiring is properly connected.
Calibrate the extruder: Calibrate the extruder by adjusting the steps per mm value in your printer's firmware. Micro Swiss provides detailed instructions for this step on their website.
Adjust the retraction settings: The retraction settings may need to be adjusted to account for the shorter distance between the extruder and the hot end with the Micro Swiss direct drive extruder.
Test print: Print a test object to make sure that everything is working properly. You may need to make further adjustments to the printer settings to get the best results with the new extruder.
It is important to note that the specific steps for setting up a Micro Swiss direct drive extruder may vary depending on the type of 3D printer you have. Therefore, it is always a good idea to consult the instructions provided by Micro Swiss and your printer's manufacturer for detailed guidance.