changing primary oil harley

Changing the primary oil on a Harley-Davidson motorcycle can help to ensure the longevity and smooth operation of the engine. Here are the steps to follow:

1. Warm up the motorcycle: Start the engine and let it run for a few minutes to warm up the oil, which will help it to flow more easily.

2. Drain the old oil: Locate the drain plug on the bottom of the primary cover, which is typically on the left side of the motorcycle. Place a drain pan underneath the plug, remove the plug, and let the old oil drain out.

3. Clean the primary cover: While the oil is draining, use a clean rag or paper towels to wipe the inside of the primary cover clean.

4. Refill with new oil: Once the old oil has drained out completely, replace the drain plug and fill the primary with new oil. The amount of oil needed will vary depending on the model of your Harley, so consult your owner's manual or a Harley mechanic for the correct amount.

5. Check the oil level: After filling the primary with new oil, start the engine and let it run for a minute or two. Then, check the oil level with the motorcycle on level ground, and add more oil if needed.

6. Dispose of the old oil properly: Used oil is hazardous waste, so be sure to dispose of it properly. Most auto parts stores will accept used oil for recycling.

Note: It's important to use the correct type of oil for your Harley's primary. Check your owner's manual or consult a Harley mechanic to ensure you're using the right oil for your bike.